EZAPs!
HERE'S HOW!
PAGE ONE
> Appx. 20" of 20g copper wire
> 1" diameter pipe about 2 to 4 inches in length
> Small tourmaline (dark green needle, short)
> Small zeolite (thomsonite)
> 6 raw garnets
> About a tablespoon of pyrite, medium ground
> Brass, steel and/or titanium shavings
(optional to use all three.)
with zeolite and
tourmaline
placing your tourmaline
in the center of your
wire and coil it clock-
wise, leaving wire
extending on either
end for the 2 sbb coils.
Then coil the top so
that it looks like an "S"
when you look down on
it, and the bottom so it
also looks like an "S"
when you flip it over.
Angle both coil's tips
downward, as shown
in the photo above.
Place a zeolite
(thomsonite) in the
center of your chamber
as shown in photo.
here. Place pipe in the center
after this layer hardens.
pyrite around the pipe as shown
here. Pour this layer and harden
before placing your core within
the pipe. Don't forget the zeolite.
shavings in around the pipe,
and pour it until it covers. If
you choose to use 2 or 3 types
of shavings, put steel and
titanium in the layer above the
pyrite, then harden, then
layer in the brass. You
may want to do 2 or 3 layers
the photos at top shows.
Put enough resin inside the pipe
to cover your core. Be careful not
to let metals get inside the pipe.
No matter if a few flakes get in
there, but the idea is NOT to block
the flow between the pipe and
the ground with a layer of metal.
All the metals are around the pipe,
not inside, as seen in the photo.