VORTEX GENERATOR
step-by-step instructions
>many yards 18&20g copper wire
>Ca. 3.25" long-1" copper pipe
>Ca. 3.25" long-1/2" copper pipe
>Ca. 3.5" long-1/4" copper or brass
pipe
(Please note, you may use larger, longer
pipes. 1", 3/4" and 1/2" copper will do
fine. Also you may cut them longer.) To
see a photo of one done like that, click
here
>a tiny, thin, dt quartz coiled within
20g wire extending above and below
to make it about 3" long.
>3 x turquoise (chips)
>12 x garnets (raw)
>12 x zeolite (thomsonite) if tiny, (or
8 of them if larger)
>1 x topaz (raw)
>1 x st quartz
>1 x tourmaline (crystal 1/2" or so)
>fine brass shavings (or other metal
may do fine, not pictured)
>pyrite, small granules (not pictured)
>plastic 8oz. yogurt container
Z=
Zeolite
Lay your crop-circle-coil
(sbb) in bottom of mold.
This view is now looking
down into the mold. (I had
it backwards before, sorry.)
This coil is supposed to
have both ends turned up-
wards just a tad. (not shown)
Arrange your garnets and
zeolites as pictured at
left. Pour a thin layer of
resin to just cover these.
Allow to harden before
next step.
Pour about 1/8" of resin in
and place your pyrite in a
doughnut shape as pictured
at right. You will be able to
see the sbb coil peeking thru
the middle, as shown in the
"re-enactment".
Leave a one inch
hole in the pyrite layer to
allow for the influx of grounding
earth energies that will travel through the bottom of the
device. Any solid metal layer
at this point would impede the
flow of energies. Tamp down
your pyrite to make an even,
flat layer. Some hematite
could be added. (Nice, but
not necessary.) Harden layer.
